Alvarion Wi^2 AP CLI Especificações descarregar pdf (Página 80)

58 BreezeMAX Wi² and BreezeACCESS Wi² System Manual

Chapter 4 - Getting Started

Ruggedized version: Remove the crossover cable, and using a standard

Ethernet cable connect the PoE injector Data In port to the network on which

the AP will be used. The network must have a DHCP server and an Internet

connection. Broadband routers typically include a DHCP server.

2 Enable your computer’s wireless network interface, and verify that it is set to

obtain an IP address automatically.

For example, in Windows XP, use Control Panel > Network Connections >

Local Area Connection > Properties > Internet Protocol (TCP/IP) >

Properties, and make sure that Obtain an IP address automatically and

Obtain a DNS server address automatically are both checked.

3 Connect to the wireless network. For example, from the Windows XP Start

menu, select Settings > Network Connections > Wireless Network

Connections. The list of available wireless networks appears. By default the

AP creates a wireless network named Alvarion Ltd.. Select this network and

then Connect.

4 Confirm that you can browse the Internet using the wireless network.

1 Make sure that your computer is configured to obtain an IP address and DNS

Server address automatically, as in step E. 2 above.

2 Connect your computer to the same network as the AP.

3 Look in the DHCP server log for the Ethernet Base MAC address shown on the

AP label and take note of the corresponding IP address.

Figure 4-5: Choosing a Wireless Network

To perform additional configuration

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 247 248

Sem comentários

Alvarion Wi^2 AP CLI Especificações Página 80