
WAN IP Interface Context
Wi² Controller CLI Reference Guide 101
passive-interface
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
passive-interface
Sets RIP to operate in passive mode (listen for routing broadcasts to update
the routing table, but do not broadcast own routes).
no passive-interface
Sets RIP to operate in active mode (listen for routing broadcasts to update
the routing table, and also broadcast own routes).
router rip
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
router rip
Enable RIP.
no router rip
Disable RIP.
ip address alternate
Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200
ip address alternate <ip address>
Assigns an alternate IP addresses to the Internet port. The address must be
valid on the Internet.
no ip address alternate <ip address>
Deletes the specified alternate IP address.
The Controller uses these addresses to support its one-to-one NAT feature.
The Controller will not respond to pings directed at these IP addresses:
Comentários a estes Manuais