Alvarion Wi^2 AP CLI Especificações descarregar pdf (Página 87)

Config Context

Wi² Controller CLI Reference Guide 61

<metrix> Indicates the priority of a route. If two routes exist for

a destination address then the Controller chooses the

one with the lower metric.

firmware distribution

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

firmware distribution (start | stop)

Starts the firmware distribution.

firmware distribution default username

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

firmware distribution default username <username> <password>

Specify the default administrator username and password to use for

firmware distribution.

The default username and password are used for satellites that do not have a

username and password specified in the distribution list.

firmware distribution load cim

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

firmware distribution load cim <uri>

Loads the distribution firmware file (*.cim) from the specified URI into the

cache.

firmware distribution load list

Supported on: Wi ²-CTRL-10 Wi ²-CTRL-40 Wi ²-CTRL-200

firmware distribution load list <uri>

Loads the distribution list from the specified URI.

The distribution list defines the set of access points that the firmware will be

installed on. The list is in XML format, with each entry composed of four

fields:

• Serial number: The serial number of the target access point.

• IP address: The IP address of the target access point.

• Username: The administrator username on the target access point.

• Password: The administrator password on the target access point.

The serial number and IP address are mandatory. The username and

password are optional. If all your satellites have the same username and

password, you can leave the username and password for every entry blank

and instead specify them with the firmware distribution default username

command.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 211 212

Sem comentários

Alvarion Wi^2 AP CLI Especificações Página 87